![]() Also try Googling "G90 digirig WSJT-X setup". Check the Device Manager for any new com ports. ![]() Turn on the computer first and give it some time to boot up. Kevin Mahoney Member October 2015 edited October 2015With the computer and radio off, make sure everything is plugged together correctly. I've only worked JT-65 on 20 and 30 but worked 100%. Test each band and check the FLEX settings as well as the WSJT-X settings. I am trying this on 20 meters during the day.First start and basic setup Raspberry pi (Raspi) Backup & Restore Install GPS Clock (Time sync & Position) Install Real Time Clock (Additional hardware) Install Packet Radio (Hamlib, Direwolf, Xastir, Linpac) Install FLRig (Transceiver Control) Install FLDigi (Data Mode) Install WSJT-X (Data Mode) Install JTDX (Data Mode)I've found you MUST go thru the setup checks each time to make sure the CAT is talking to the correct port and that the DAX is connected for TX. Flrig can talk to the G90, WSJTX is receiving fine, and Grid Tracker is mapping. I have also setup my laptop to sync its time on a regular basis. I have installed Flrig, Fldigi, WSJTX, and Grid tracker. ![]()
0 Comments
Leave a Reply. |